Electrical Connections - Advanced Energy AE 75TX Installation And Operation Manual

Advanced Energy
4. Attach water-tight NEMA 4 conduit hubs in each hole.
The inve1ter is a NEMA 4 enclosure. Use only rain-tight or wet-location
conduit hubs and install these hubs as shown in the following figure.
Lower cabinet gland plate
2 inch straight metal conduit connector
Figure 4-10. Installation of conduit hub
&
CAUTION:
For outdoor installations make liquid-tight connections to the unit.
Lt,
ATTENTION:
Pour les installations exterieures, effectuer des connexions etanches
a
l'unite.
5. Replace the gland plate, taking care to evenly seat the gasket material against
the cabinet.
Important
Remove all metal shavings and wire scraps from the inve1ter p1ior to
replacing the gland plates.
6. Tighten the screws until the gland plate is snug.
Do not ove1tighten.
ELECTRICAL CONNECTIONS
4-10
&
DANGER:
Electrical connections must comply with national and local standards.
Voltage drop and other considerations may dictate that larger wire sizes be
used.
Installing
570-1001793-0SB