Lifting And Mounting The Inverter - Advanced Energy AE 75TX Installation And Operation Manual

Advanced Energy
Figure 4-7. Air filter check
LIFTING AND MOUNTING THE INVERTER
The inve1ter base is designed to allow a properly rated forklift to lift it from the front
or back using the fork slots.
a:F
Important
Before installing the inve1ter, make sure the pre-installation inspection steps
have been completed and no issues have been identified.
Mounting Requirements
• Mount the unit on a flat surface in an up1ight position.
• The mounting smface must comply with all national and local standards for
weight, seismic, and wind sheer requirements.
• The mounting smface must be prepared according to the site specific stmcttll'al
drawing.
Parts and Tools Required
4-6
• Use a lifting device such as forklift or a pallet jack or an alternate method of
lifting and positioning the inve1ter. Lifting devices must be rated for the weight
of the inve1ter. Proper lifting methods may include:
0
Using a crane with a strap rated for the weight of the inve1ter
Installing 570-1001793-0SB