Advanced Energy AE 75TX Installation And Operation Manual page 64

Advanced Energy
4-18
&
DANGER:
Avant d'effectuer les branchements CC, assurez-vous que les piles PV sont
deconnectees de l'onduleur en utilisant le connecteur CC externe.
&
DANGER:
Make sure the PV array polarity and voltage between the positive and
negative cables are correct before connecting the PV array cables to the DC
terminal block.
&
DANGER:
Assurez-vous que la polarite et le voltage des <:Ables positifs et negatifs des
piles PV sont corrects avant de brancher les <:Ables des piles PV aux bomes
CC.
&
DANGER:
Risk of electrical shock. When exposed to light, PV arrays create electrical
energy that could cause a hazardous condition.
Lt_
DANGER:
Risque d'electrocution. Lorsqu'elles sont exposees
a
la lumiere, les piles
photovolta"iques generent un courant electrique susceptible de causer des
conditions dangereuses.
Follow these steps to wire the DC inputs from the PV panels to the inve1ter. These
instrnctions are for a negatively grounded anay. For a positively grounded a1rny, use
the opposite tenninals.
Tools Required
• 5/32" Allen wrenches (Allen wrench adaptor for a socket wrench
recommended)
• Open-end wrench or socket wrench
• Torque wrench
• Voltmeter
To Connect the DC Wiring
1. Disconnect power to the DC wiling by disconnecting the PV anay outside the
inve1ter before sta1ting the DC wiring.
2 . Clearly mark the anay positive and negative leads.
3. Route the PV anay leads through the conduit to the desired ently gland plate
on the DC side of the inve1ter.
Installing
570-1001793-0SB