Ac Wiring - Advanced Energy AE 75TX Installation And Operation Manual

Advanced Energy® AE ?STX and AE 1 OOTX Inverters
it
DANGER:
Les connexions electriques doivent etre conformes aux normes nationales et
locales. Des chutes de tension et autres facteurs peuvent imposer l'usage de
fils de plus gros calibre.
it
DANGER:
RISK OF DEATH OR BODILY INJURY. Disconnect and lockout/tagout all
sources of input power before working on this unit or anything connected to
it.
it
DANGER:
RISQUE DE MORT OU DE BLESSURES CORPORELLES. Debrancher et
verrouiller/etiqueter toutes les sources de puissance d'entree avant de
travailler sur cette unite ou sur tout element qui y est raccorde.
After the inve1 ter is properly secured to the mounting pad and the conduit hubs have
been installed, the electrical connections can be completed. Tem1inal connections for
the inve1 ter are located inside the inve1 ter. When facing the inve1ter, the connections
are located in the following areas:
• DC tenninals are on the left side
• AC tenninals are on the iight side
Both AC and DC bus bars accept standard te1minal lug-climped wires mounted to the
bus bar fittings with standard grade 8, 3/8" mounting hardware.
AC Wiring
Important
The inve1 ter is ce1 tified for installation without a neutral conductor. Do NOT
pull a neutral conductor from the AC service panel to the inve1ter.
The inve1ter
is designed for use with the following three-phase power grids.
• 208 VAC
• 480VAC
• 600VAC
Important
The inve1 ter must be connected to a grounded wye configuration.
The voltage output is not selectable on AE inve1ters. Do not attempt to change the
AC output voltage once it is set at the facto1y.
Use the applicable national and local electrical codes to select the appropriate AC
wire sizing for your application. Conect wire sizing requires, at a rninimum,
570-1001793-0SB
Installing
4-11