Electrical Connections - Advanced Energy AE 600 User Manual

5. Replace the gland plate taking care to evenly seat the gasket material against
the cabinet.
6. Tighten until the gland plate is snug. Do not overtighten.

ELECTRICAL CONNECTIONS

DANGER:
Electrical connections must comply with national and local standards.
Voltage drop and other considerations may dictate that larger wire sizes be
used.
DANGER:
Les connexions électriques doivent être conformes aux normes nationales et
locales. Des chutes de tension et autres facteurs peuvent imposer l'usage de
fils de plus gros calibre.
DANGER:
RISK OF DEATH OR BODILY INJURY. Disconnect and lockout/tagout all
sources of input power before working on this unit or anything connected to
it.
DANGER:
RISQUE DE MORT OU DE BLESSURES CORPORELLES. Débrancher et
verrouiller/étiqueter toutes les sources de puissance d'entrée avant de
travailler sur cette unité ou sur tout élément qui y est raccordé.
After the inverter is properly secured to the mounting pad and the conduit hubs have
been installed the electrical connections can be completed. Terminal connections for
the inverter are located inside the inverter. When facing the inverter the connections
are located in the following areas:
• DC terminals are on the left side
• AC terminals are on the right side
Both AC and DC bus bars accept standard terminal lug-crimped wires mounted to the
bus bar fittings with standard grade 8, 3/8" mounting hardware.
For the optional DC circuit breaker subcombiners, the conductor is connected to the
bus bar provided for each breaker or inserted directly into the DC circuit breaker
frame depending on the configuration. The following table lists the accepted wire
sizing for each subcombiner lug option.
570-1001791-05A
Advanced Energy® AE 500 Inverter
Installing 4‑15