Advanced Energy AE 75TX Installation And Operation Manual page 53

Advanced Energy® AE ?STX and AE 1 OOTX Inverters
0
Using lifting beams, spreader bars, or similar equipment rated for the weight
of the inve1ter
• Anchoring hardware: Grade 8 hardware is required.
To Lift and Mount the Unit
LL
WARNING:
Do
not attempt to lift the full weight of the unit from the left or right sides only.
Attempting to lift from just the left or right sides only will result in an unstable
and unsafe condition.
&
AVERTISSEMENT:
Ne pas tenter de soulever l'unite uniquement
a
partir du cote gauche ou
droit. Toute tentative de soulever l'unite par le oote gauche
OU
droit pourrait
occasionner une situation d'instabilite dangereuse.
&
CAUTION:
Care MUST be taken to protect the inverter from compressive stresses or
forces which may dent or deform the cabinet or cause damage to the
inverter. Damage caused by improper handling may void the warranty. Safe
handling, operating, and installation practices are the responsibility of the
installer.
&
ATTENTION:
Redoubler de vigilance pour proteger l'inverseur des contraintes ou forces en
compression qui peuvent endommager ou deformer l'armoire ou
endommager l'inverseur. Les dommages causes par la manipulation
inadequate peuvent annular la garantie. Les pratiques securitaires de
manipulation, de fonctionnement et d'installation incombent
a
l'installateur.
Important
Damage caused by improper handling can void the wan anty. Safe operating,
handling, and installation practices are the responsibility of the installer .
1.
Prepare the mounting smface according to the site-specific strnctural drawing.
2. Lift the inve1 ter off the pallet using the forklift slots on the front or back. The
side fork slots are not designed for lifting the inve1ter.
The front and back of the inve1ter base each have two fork slots that are
109
mm (7.5") wide and 673 mm (26.5") apait on center.
570-1001793-0SB
Important
The center of gravity is toward the back, lower third of the inve1ter and
centered side to side. Refer to the mechanical drawings to view the
center of gravity location.
Installing 4-7