Advanced Energy AE 75TX Installation And Operation Manual page 82

Advanced Energy
6-4
Important
The Ethernet cable must comply with T-568B standards as shown in the
following figure. This is the only configuration suppo1 ted by the data
monit01ing module. Other wiling configurations will not work.
Front
1 2 3 4 5 6 7 8
I
u
~
'
Bottom
~
t
I
OIO
GI
8 81Gll'19r
_ _ _ _ _ _ 4352
Figure 6-2. T-5688 compliant Ethernet cable
2 . Plug the Ethernet cable into the Ethernet po1t on the communication inte1face
PCB located in the data monitoring section of the inve1ter.
Inverter control wire harness connectors
---==~ Remote
disable terminal block
==-- - -
Screws to remove remote disable terminal block
Modbus slave port terminal blocks
RJ45 Ethernet port
Figure 6-3. Communication interface PCB Ethernet port location
Related Links
• "Conduit Enny Points" on page 4-8
Data Monitoring and Controls 570-1001793-0SB