Preventive Maintenance; Safety Conditions; Condition Of The Housing; Condition Of Cables And Terminals - Ingeteam INGECON SUN 1Play TL M Installation And Usage Manual

Ingeteam

16. Preventive maintenance

The recommended preventive maintenance tasks must be carried out at least ANNUALLY, except where otherwise
stated.

16.1. Safety conditions

You must consider the set of conditions listed below as minimum requirements.
Before opening the unit, you must remove the power (see Section "15. Shutting down the unit").
Opening the housing does not imply, in any case, the absence of voltage in the unit. Access to it
should only be gained by qualified personnel and by following the security conditions established in
this document.
Ingeteam accepts no liability for any damages caused by improper use of the equipment. Any work
carried out on any equipment which implies a modification of the original electrical arrangements
must be proposed in advance to Ingeteam. These must be studied and approved by Ingeteam.
All the maintenance checks included here must be carried out with the machine stopped, under safe
conditions for handling, including those specified by the client for these types of operation.
When carrying out maintenance work on the unit, the Personal Protective Equipment specified in
Section "3.2. Personal Protective Equipment (PPE)" of this document must be worn.
After completing the maintenance task, replace the front cover and secure it with the bolts supplied.

16.2. Condition of the housing

A visual check of the condition of the housing must be carried out, confirming the condition of the seals and the
cover, as well as the fixing of the units to their anchor points on the wall. In addition, you must check the condition
of the housing for dents or scratches that might degrade the housing or cause it to lose its protection classification.
If you notice these types of defect, the affected parts must be repaired or replaced.
Check that there is no moisture inside the housing. If moisture exists, you must dry it before making electrical
connections.
Check the correct fixing of the housing components to their corresponding anchoring points.
Check the door seal of the unit is in good condition.

16.3. Condition of cables and terminals

• Check the correct path of the cables so they do not come into contact with live parts.
• Check the insulation deficiencies and hot spots by checking the colour of the insulation and terminals.
• Check that the connections are properly adjusted.

16.4. Cooling system

Clean the radiator fins and the cooling grids.

16.5. Environment

Check the environment to avoid amplifying or transmitting the buzz.
80
Preventive maintenance
ABE2011IQM01_ - Installation and usage manual