Table of Contents
Advertisement
Installation and Operation Manual
INGECON®SUN SMART U
AAS2000IKI05
9
Operating the display
ESC
9.1 Keypad and LEDs
ESC
OK
AAS2000IKI05
Rev. _
Date: February 2011
The Ingecon® Sun inverters are equipped with a "Screen and
Keypad" set for man - machine communication.
This interface allows the key internal parameters to be displayed
and makes it possible to adjust the entire system during installation.
The parameters, variables and commands are organised into
OK
menus and sub-menus.
The keypad comprises the following four keys:
Esc. To exit the parameter exit mode without making changes, to exit a
menu and return to a higher level, to not confirm or not accept a change
or proposal.
Up. To scroll up a list of parameters or folders with the same level, or to
increase the value of an editable parameter by one basic unit.
Down. To scroll down a list of parameters or folders with the same level, or
to decrease the value of an editable parameter by one basic unit.
OK. To validate a parameter change, to access a lower level menu, to
confirm a change or to accept a proposal.
There are three LEDs on the faceplate as follows:
Green LED.
Slow flashing: On-hold status due to low irradiance.
Fast flashing: Start-up process.
On: inverter connected to the grid.
Orange LED.
Fast flashing: Alarm triggered, which does not stop the inverter from
operating.
Red LED.
ON: Alarm triggered which shuts down the inverter.
Special combinations:
Rapid flashing of all three LEDs: Fatal error status.
Page 59
Advertisement
Table of Contents
