Display Control; Keypad And Leds - Ingeteam INGECON SUN 1Play TL M Installation And Usage Manual

Display control

12. Display control
These units incorporate a display + keypad unit for communication with the
installer and the user.
This interface allows the display of the main internal parameters and the
configuration of the entire system during installation.
Parameters, variables and commands are organised as menus and submenus.

12.1. Keypad and LEDs

The keypad has four keys:
To exit a parameter, leave a menu and return to the next level up in the structure, to not confirm
a change or not accept a suggestion.
With this key you can scroll up the list of parameters or folders within the same level or increase
the value of an editable parameter by one base unit.
To scroll down the list of parameters or folders within the same level or decrease the value of an
editable parameter by one base unit.
Serves to accept a parameter as valid, to enter a lower level menu in the structure, to confirm a
change or accept a suggestion.
The panel consists of three LEDs, green orange and red:
Green LED
Off: inverter disconnected.
On: inverter connected to the grid.
Flashes once: the conditions are not valid for feeding the grid (low Vdc voltage or
other alarm).
Flashes six times: the connection conditions are valid. The inverter is in the process
of connecting to the mains.
Orange LED
Consult section "17. Troubleshooting".
Red LED
Consult section "17. Troubleshooting".
ABE2011IQM01_ - Installation and usage manual
Ingeteam
DE
EN
ES
FR
IT
PT
71