When Receiving No Reply - Icom ID-31E PLUS Basic Manual

■ When receiving no reply

To communicate through the repeater, your signal must access to the repeater. The following chart is designed to help you
correct problems which are not equipment malfunctions.
PROBLEM
After your call, the repeater does
not return a status reply.
After your call, the repeater replies
'UR?' and its call sign.
After your call, the repeater replies
'RX' or 'RPT?' and the access
repeater's call sign.
After your call, the repeater replies
'RPT?' and the access repeater's
call sign.
POSSIBLE CAUSE
• The repeater setting is wrong.
• Your transmission did not reach the repeater.
The call was successfully sent, but no station
immediately replied.
• Your own call sign (MY) has not been set.
• Your own call sign (MY) has not been
registered on a gateway repeater, or the
registered contents do not match your
transceiver's settings.
The call sign of the destination repeater is
wrong.
D-STAR OPERATION
SOLUTION
• Select the correct repeater.
• Correct the repeater frequency, frequency
offset, or duplex settings.
• Wait until you are closer to the repeater and
try again.
• Try to access another repeater.
Wait for a while, and try again.
• Set your own call sign (MY).
• Register your own call sign (MY) on a gateway
repeater, or confirm the registration of the call
sign.
Correctly set the destination repeater call sign.
REF.
p. 60
—
—
—
—
p. 39
p. 41
—
62
D-STAR GUIDE