Ate Set Command Echo Mode; Ath Disconnect Existing Connection; Ati Display Product Identification Information - SimCom SIM5300E At Command Manual

Reference
V.25ter
2.2.5

ATE Set Command Echo Mode

ATE Set Command Echo Mode
Execution Command
ATE<value>
Parameter
Reference V.25ter
2.2.6

ATH Disconnect Existing Connection

ATH Disconnect Existing Connection
Execution Command
ATH
Reference V.25ter
2.2.7

ATI Display Product Identification Information

ATI Display Product Identification Information
SIM5300E AT Command Manual V1.02
If connection successful and non-voice call.
CONNECT<text> TA switches to data modeWhen TA returns to Command
mode after call release
OK
If successfully connected and voice call
Note:
This Command may be aborted generally by receiving an ATH

Command or a character during execution. The aborting is not
possible during some states of connection establishment such as
handshaking.
<text> output only if ATX<value> parameter setting with the

<value> >0
Response
This setting determines whether or not the TA echoes characters received
from TE during Command state.
OK
<value>
0 Echo mode off
1 Echo mode on
Response
Disconnect existing call by local TE from Command line and terminate call
OK
Note: OK is issued after circuit 109(DCD) is turned off, if it was previously
on.
9