At+Smtpcs Set The Email Charset - SimCom SIM5300E At Command Manual

Parameter
Reference

14.2.12 AT+SMTPCS Set the Email Charset

AT+SMTPCS Set the Email Charset
Test Command
AT+SMTPCS=?
Read Command
AT+SMTPCS?
Write Command
AT+SMTPCS=
<charset>
Parameters
Reference
SIM5300E AT Command Manual V1.02
+SMTPSEND: <code>
<reqLength> Requested number of data bytes(0-<maxLength>) to be
transmitted
<cnfLength> Confirmed number of data bytes to be transmitted
<maxLength> The max length of data can be sent at a time. It depends on
the network status.
<code> See AT+SMTPSEND
Note:
<reqLength> cannot be greater than <maxLength>.

When "+SMTPFT:

AT+SMTPFT=<reqLength> to send data.
Response
+SMTPCS: <charsetLength>
OK
Response
+SMTPCS: <charset>
OK
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
<charset> The Email charset, string type. It shows which charset the
subject and the body are encoded in. If <charset> is not ASCII but UTF-8 or
other, the subject and the body must be in hexadecimal format (e.g. "TEST"
should be converted to "54455354").
The default charset is ASCII.
<charsetLength> The max length of <charset>.
Note
1,<maxLength>" is reported, then use
236