SimCom SIM5300E At Command Manual page 153

SIM5300E AT Command Manual V1.02
ratio indicates the bit error ratio in the delivered SDUs. The value is specified
as 'mEe'. As
an example a target residual bit error ratio of 5.10-3 would be specified as
'E3' (e.g.
AT+cgeqreq=....,"5E3",...) (refer 3GPP TS 24.008 [8] subclause 10.5.6.5).
<Delivery_of_erroneous_SDUs>
A numeric parameter that indicates whether SDUs detected as erroneous
shall be
delivered or not.
0 no
1 yes
2 no detect
Other values are reserved.
<Transfer_delay>
A numeric parameter (0,1,2,...) that indicates the targeted time between
request to
transfer an SDU at one SAP to its delivery at the other SAP, in milliseconds
(refer 3GPPTS 24.008 [8] subclause 10.5.6.5).
<Traffic_handling_priority>
A numeric parameter (1,2,3,...) that specifies the relative importance for
handling of all SDUs belonging to the UMTS bearer compared to the SDUs of
other bearers (refer 3GPPTS 24.008 [8] subclause 10.5.6.5).
<Source_Statistics_Descriptor>
Supported in R7 P S a numeric parameter that specifies characteristics of the
source of the submitted SDUs for a PDP context. This parameter should be
provided if the Traffic
class is specified as conversational or streaming (refer 3GPP TS 24.008 [8]
subclause
10.5.6.5).
0 Characteristics of SDUs is unknown (default value)
1 Characteristics of SDUs corresponds to a speech source
Other values are reserved.
<Signalling_Indication>
Supported in R7 P S a numeric parameter used to indicate confirmat content
of submitted SDUs for a PDP context. This parameter should be provided if
the Traffic class is specified as interactive (refer 3GPP TS 24.008 [8] subclause
10.5.6.5).
0 PDP context is notoptimized for confirmat (default value)
1 PDP context is optimized for confirmat
142