At+Clir Calling Line Identification Restriction - SimCom SIM5300E At Command Manual

Reference
3.2.19

AT+CLIR Calling Line Identification Restriction

AT+CLIR Calling Line Identification Restriction
Test Command
AT+CLIR=?
Read Command
AT+CLIR?
Write Command
AT+CLIR=<n>
Parameters
SIM5300E AT Command Manual V1.02
0 CLIP not provisioned
1 CLIP provisioned
2 unknown (e.g. no network, etc.)
Response
+CLIR: (list of supported <n>s)
OK
Response
+CLIR: <n>, <m>
OK
If error is related to ME functionality:
+CME ERROR: <err>
Response
TA restricts or enables the presentation of the CLI to the called party when
originating a call.
The Command overrides the CLIR subscription (default is restricted or
allowed) when temporary mode is provisioned as a default adjustment for all
following outgoing calls. This adjustment can be revoked by using the
opposite Command.
OK
If error is related to ME functionality:
+CME ERROR: <err>
<n> (parameter sets the "Call line identification" adjustment for outgoing
calls:):
0 presentation indicator is used according to the subscription of
the CLIR service
1 CLIR invocation
2 CLIR suppression(default)
<m> (parameter shows the subscriber CLIR service status in network):
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
40