Honda Acura NSX 1991 Service Manual page 66

27. Disconnect the three connectors, then remove the
emission control box. Fix it to the intake manifold.
10 Nom (I .O kg-m,
7 lb-ft)
28. Move the trunk carpet and disconnect the anti-lock
brake right sensor connector. Push the wire and
connector throuah the bodv hole into the engine
compartment.
29. Remove the front engine mounting bolt (page
5-28).
ANTI-LOCK BRAKE SENSOR
WIRE CONNECTOR
30. Raise hoist to full height.
31. Remove the clutch slave cylinder from the
EMISSION CONTROL
32. Remove the lower cover, then remove the shift
33. Remove the cover, then remove the shift cable
34. Remove the engine under guard and the center rod
transmission case (M/T, See Section 12)
cable and select cable with cable bracket (M/T, See
Section 13).
(A/T See Section 14).
NOTE:
l Take care not to bend the cable when removing
it. Always replace a kinked cable with a new
one.
assembly.
SHIFT
22 Nom (2.2 kg-m.
16 lb-ft)
6 x l.Omm
UNDER GUARD
2 5 m m
60 N*m (6.0 kg-m, 43 lb-ft)
ROL LEVER
0.8 Nom (8 kg-m, 6 lb-ftl
12 N-m (I .2 kg-m, 9 lb-ft)