SMART Embedded Computing AXP1440-C07 Installation And Use Manual page 127

5. Loosen the correlating internal captive screw using the alignment tool found in the rear
of the shelf.
6. Remove the alignment tool from its stowed position, by loosening the four
thumbscrews.
7. Position the alignment tool over slot 6 or 9, so that the UP is facing up.
8. Securely fasten the thumb screws of the alignment tool.
9. Use a #1 Phillips screwdriver through the alignment hole in the tool and loosen the
internal captive screw.
10. After the internal captive screw has been loosened, return the alignment tool to its
stowed position with the UP facing to the left.
11. Unlatch the front blade handle and pull the handle fully outward until the blade is
detached from the shelf.
NOTE: If the blade does not come loose for slots 6 and 9, check that the internal captive
screw mentioned earlier is completely unfastened.
12. Remove the face plate cables, if applicable.
13. Remove the blade from the shelf.
AXP1440-C07 Installation and Use (6806800V18A)
FRU Installation
125