5.12.2.2 Pem Upgrade Sample Output - SMART Embedded Computing AXP1440-C07 Installation And Use Manual

5.12.2.2 PEM Upgrade Sample Output

The sample output for this command for one PEM is shown below.
# upgradepem pem1 /tmp/pem1620.img
Upgrading...
upgradefw -I /dev/i2c5:0x66 /tmp/pem1620.img
BMR-AVR firmware upgrade utility. Pigeon Point Systems (c) 2004.
Upgrade interface: IPMB, device: /dev/i2c5, options: 0x66
Firmware upgrade image: /tmp/pem1620.img
Preparing Master AVR for programming .................. OK
Programming 39703 bytes to Master AVR at 000000 ... 100%
Preparing Slave AVR for programming ... OK
Programming 7008 bytes to Slave AVR at 000000 ... 100%
upgradefw returned 0.
/bin/upgradepem: Upgrade complete.
Verify firmware version:
# clia ipmc -v 0x66
Pigeon Point Shelf Manager Command Line Interpreter
66: Entity: (0xa, 0x60) Maximum FRU device ID: 0x01
PICMG Version 2.1
Hot Swap State: M4 (Active), Previous: M3 (Activation In
Process), Last State Change Cause): Normal State Change (0x0)
Device ID: 0x01, Revision: 0, Firmware: 1.03 (ver. 1.0.3), IPMI
ver 1.5
Manufacturer ID: 0000a1, Product ID: 005e, Auxiliary Rev:
00000018
Device ID String: "PEM1620"
Device Capabilities (0x29)
Controller provides Device SDRs
Supported features: 0x29
AXP1440-C07 Installation and Use (6806800V18A)
Global Initialization: 0xc, Power State Notification: 0xc,
"Sensor Device" "FRU Inventory Device" "IPMB Event Generator"
AXP1440-C07 Shelf Installation
109