Table of Contents
Advertisement
3. POSITIONING SIGNAL
(2) Rapid stop command (M3201+20n)
(a) The rapid stop command is a signal used to rapidly stop an axis that is
currently being driven and becomes effective at its leading edge
(OFF→ON). (An axis for which the rapid stop command is ON cannot be
started.)
Rapid stop
OFF
command
(M3201+20n)
V
Set speed
(b) The details of stop processing when the rapid stop command comes ON
are presented in the table below.
Control Being
Executed
Position control
The axis decelerates to a stop in the
Speed control (I, II)
deceleration time set in the parameter
block or servo program.
JOG operation
Manual pulse
An immediate stop is executed, with
generator operation
no deceleration processing.
(1) The axis decelerates to a stop in the rapid stop deceleration time set in
Zeroing
(2) A "stop during zeroing" error occurs and the error code (203) is stored in
POINT
If a stop is executed by turning ON the rapid stop command (M3201+20n)
during a zeroing operation, re-execute the zeroing operation. If the rapid stop
command came ON after the proximity dog came ON in the zeroing
operation, first retract to a position before the point where the proximity dog
comes ON using JOG operation or positioning, and then execute the zeroing
operation again.
Processing when the Rapid Stop Command Comes ON
If Control is Being Executed
the parameter block.
the minor error storage area for each axis.
3 − 17
ON
Rapid stop command
for designated axis
Control when rapid
stop command is OFF
Stop
Rapid stop processing
If Deceleration Stop Processing is
Being Executed
Deceleration processing is canceled
and rapid stop processing executed
instead.
t
Hide quick links:
Advertisement
Table of Contents
