Mitsubishi Electric A173UHCPU Programming Manual page 9

Do not touch the lead sections such as ICs or the connector contacts.
Do not place the control unit or servo amplifier on metal that may cause a power leakage or
wood, plastic or vinyl that may cause static electricity buildup.
Do not perform a megger test (insulation resistance measurement) during inspection.
When replacing the control unit or servo amplifier, always set the new unit settings correctly.
When the controller or absolute value motor has been replaced, carry out a home position
return operation using one of the following methods, otherwise position displacement could
occur.
1) After writing the servo data to the PC using peripheral device software, switch on the
power again, then perform a home position return operation.
2) Using the backup function of the peripheral device software, load the data backed up
before replacement.
After maintenance and inspections are completed, confirm that the position detection of the
absolute position detector function is correct.
Do not short circuit, charge, overheat, incinerate or disassemble the batteries.
The electrolytic capacitor will generate gas during a fault, so do not place your face near the
control unit or servo amplifier.
The electrolytic capacitor and fan will deteriorate. Periodically change these to prevent
secondary damage from faults. Replacements can be made by the Service Center or
Service Station.
(9) Disposal
Dispose of this unit as general industrial waste.
Do not disassemble the control unit, servo amplifier or servomotor parts.
Dispose of the battery according to local laws and regulations.
(10) General cautions
All drawings provided in the instruction manual show the state with the covers and safety
partitions removed to explain detailed sections. When operating the product, always return
the covers and partitions to the designated positions, and operate according to the
instruction manual.
CAUTION
CAUTION
CAUTION
− VIII −