High Speed Settings - Cycle832 - Siemens SINUMERIK 840D sl Programming Manual

Programming cycles externally
18.1 Technology cycles
Note
If the following transfer parameters are programmed indirectly (as parameters), the input
mask is not reset: _FR, _ST, _TC, _MODE, _DIR
Can be selected when function is set up in IBN SWIVEL
1)
Can be selected if direction reference to rotary axis 1 or 2 is set in IBN SWIVEL
2)
If direction reference is "no" there is no selection field
Swivel selection "no" can be grayed out SD 55221 Bit 0
3)
Swivel "no", "minus" direction corresponds to _DIR = 0 and _ST TEN THOUSANDS = 1
Swivel "no", "plus" direction corresponds to _DIR = 0 and _ST TEN THOUSANDS = 2
The direction selection for rotary axis 1 or 2 also occurs if the rotary axis with the direction
4)
reference is in the pole position (position value equals zero).
Coding example: Axis-by-axis rotation, rotary sequence ZYX
5)
Binary: 00011011 Decimal: 27
The axis identifiers XYZ correspond to the geometry axes of the NC channel. Individual
rotations around the XYZ axes are permissible. Example: rotary sequence around ZXZ is not
permitted in one call of CYCLE800.
18.1.39

High Speed Settings - CYCLE832

Programming
CYCLE832(REAL S_TOL, INT S_TOLM, REAL S_OTOL)
Note
CYCLE832 does not relieve the machine manufacturer from optimization tasks that are
necessary when commissioning the machine. This involves the optimization of the axes
involved in the machining process and NCU settings (pre-control, jerk limiting, etc.).
Parameters
No. Param Param
mask internal
1 Toler- S_TOL
ance
714
Explanation
Contour tolerance
The contour tolerance corresponds to the axis tolerance of the geometry axes.
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Job Planning