Special Handling Of Tool Offsets - Siemens SINUMERIK 840D sl Programming Manual

Meaning
DELDL
<t>
<d>
DELDL[<t>,<d>]
DELDL[<t>]
DELDL
<status>
Note
Wear and setting-up values of active tools cannot be deleted (essentially the same as the
delete behavior of
9.3

Special handling of tool offsets

Function
The evaluation of the sign for tool length and wear can be controlled using setting data
SD42900 to SD42960.
The same applies to the behavior of the wear components when mirroring geometry axes or
changing the machining plane, and also to temperature compensation in tool direction.
Wear values:
If reference is made to wear values in the following, then this should be understood as the
sum of the actual wear values ($TC_DP12 to $TC_DP20) and the sum offsets with the wear
values ($SCPX3 to $SCPX11) and setting-up values ($ECPX3 to $ECPX11).
More information on summed offsets, refer to:
References:
Function Manual, Tool Management
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Command to delete additive offsets
T number of the tool
D number of the tool cutting edge
All additive offsets of the cutting edges
All additive offsets of all cutting edges of tool
All additive offsets of all cutting edges of all tools of the TO unit are
deleted (for the channel in which the command is programmed).
Delete status
Value: Meaning:
0 Deletion was successfully completed.
- Offsets have not been deleted (if the parameter settings
specify exactly one tool edge), or not deleted completely (if
the parameter settings specify several cutting edges).
or tool data).
D
9.3 Special handling of tool offsets
of the tool are deleted.
<d> <t>
are deleted.
<t>
Tool offsets
391