Siemens SINUMERIK 840D sl Programming Manual page 653

No. Param Param
mask internal
_PITA
13
14 _TECHNO
_PITM
15
16 _PTAB
17 _PTABA
18 _GMODE
19 _DMODE
20 _AMODE
Technology fields may be hidden, depending on the setting date SD52216 MCS_FUNCTION_MASK_DRILL
1)
Parameters 15, 16 and 17 are only used for thread selection in the input mask thread tables. The thread tables cannot
2)
be accessed via cycle definition in cycle run time.
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Explanation
Pitch unit (evaluation of PIT and MPIT)
0 = Pitch in mm
1 = Pitch in mm
2 = Pitch in TPI
3 = Pitch in inches
4 = MODULE
Technology
1)
UNITS: Exact stop response
0 = Exact stop active as before cycle call
1 = Exact stop G601
2 = Exact stop G602
3 = Exact stop G603
TENS: Feedforward control
0 = With/without feedforward control active as before cycle call
1 = With feedforward control FFWON
2 = Without feedforward control FFWOF
String as marker for pitch input
String for thread table ("", "ISO", "BSW", "BSP", "UNC")
String for selection from thread table (e.g. "M 10", "M 12", ...)
Reserved
Display mode
UNITS: Machining plane G17/G18/G19
0 = Compatibility, the plane effective before cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
TENS: Reserved
HUNDREDS: Reserved
THOUSANDS: Compatibility mode (or recompilation input mask only), if MD 52216 bit0 = 1
0 = Technological parameters are displayed (compatibility): TECHNO parameters effective
1 = Technology parameters are not displayed: technology active "as before cycle call"
Alternative mode
UNITS: Drilling depth Z1 (abs/inc)
0 = Compatibility, from DP/DPR programming
1 = Incremental
2 = Absolute
- evaluation of MPIT/PIT
- evaluation of PIT
- evaluation of PIT (threads per inch)
- evaluation of PIT
- evaluation of PIT
2)
Programming cycles externally
18.1 Technology cycles
2)
2)
1)
653