Programmable Parameter Set Changeover (Scpara) - Siemens SINUMERIK 840D sl Programming Manual

Program code
ENDIF
M17
ENDIF
...
The tool can then be retracted in JOG mode by means of a retraction movement towards the
tool axis.
16.5

Programmable parameter set changeover (SCPARA)

Function
The changeover to a specific parameter set can be requested for an axis with the
command.
Note
No parameter set changeover during thread cutting
During thread cutting
controller and cannot be changed.
Disabled parameter set changeover
A parameter set changeover can also be requested via the NC/PLC interface. In order to
avoid changeover conflicts, the parameter set changeover of the NC (
disabled via the NC/PLC interface:
DB31, ... DBX9.3 (parameter set specification disabled by NC)
Note
If a parameter set changeover is requested by
disabled via the NC/PLC interface, the changeover is rejected without an error message.
Syntax
SCPARA[<axis>]=<value>
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
16.5 Programmable parameter set changeover (SCPARA)
Comment
and tapping /
G33 G331 G332
, the parameter set is selected by the
while the parameter set changeover is
SCPARA
Additional functions
SCPARA
) can be
SCPARA
593