Longitudinal Slot - Slot1 - Siemens SINUMERIK 840D sl Programming Manual

18.1.20

Longitudinal slot - SLOT1

Programming
SLOT1 (REAL RTP, REAL RFP, REAL SDIS, REAL _DP, REAL _DPR, INT NUM,
REAL LENG, REAL WID, REAL _CPA, REAL _CPO, REAL RAD, REAL STA1, REAL
INDA, REAL FFD, REAL FFP1, REAL _MID, INT CDIR, REAL _FAL, INT VARI,
REAL _MIDF, REAL FFP2, REAL SSF, REAL _FALD, REAL _STA2, REAL _DP1,
INT _UMODE, REAL _FS, REAL _ZFS, INT _GMODE, INT _DMODE, INT _AMODE)
Parameters
No. Param Param
mask internal
RP RTP
1
Z0 RFP
2
3 SC SDIS
4 Z1 _DP
5 _DPR
6 NUM
L LENG
7
8 W WID
9 X0 _CPA
10 Y0 _CPO
11 _RAD
12 α STA1
INDA
13
FZ FFD
14
15 F FFP1
16 DZ _MID
17 CDIR
18 UXY _FAL
19 VARI
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Explanation
Retraction plane (abs)
Reference point of tool axis (abs)
Safety clearance (to be added to reference point, enter without sign)
Slot depth (abs)
Slot depth (inc) with respect to Z0 (enter without sign)
Number of slots = 1
Slot length
Slot width
Reference point in the 1st axis of the plane
Reference point in the 2nd axis of the plane
Reserved
Angle of rotation
Reserved
Depth infeed rate
Feedrate
Maximum depth infeed
Milling direction
0 = Down-cut
1 = Up-cut
Finishing allowance on plane or slot edge
Machining type
UNITS:
0 = Reserved
1 = Roughing
2 = Finishing
4 = Edge finishing (only machine the edge)
5 = Chamfer
TENS: Approach
Programming cycles externally
18.1 Technology cycles
673