Delete Additive Offsets (Deldl) - Siemens SINUMERIK 840D sl Programming Manual

Tool offsets
9.2 Additive offsets
System variables
System variable
$TC_SCPxy[<t>,<d>]
$TC_ECPxy[<t>,<d>]
<t>: T number of the tool
<d>: D number of the tool cutting edge
Note
The defined wear and setup values are added to the geometry parameters and the other
offset parameters (D numbers).
Example
The wear value of length 1 is set to the value of 1.0 for the cutting edge <d> of tool <t>.
Parameter: $TC_DP3 (length 1, with turning tools)
Wear values: $TC_SCP13 to $TC_SCP63
Setup values: $TC_ECP13 to $TC_ECP63
$TC_SCP43 [<t>,<d>] = 1.0
9.2.3

Delete additive offsets (DELDL)

Function
The
memory space). Both the defined wear values and the setup values are deleted.
Syntax
DELDL[<t>,<d>]
DELDL[<t>]
DELDL
<Status>=DELDL[<t>,<d>]
390
command deletes the additive offsets for the cutting edge of a tool (to release
DELDL
Significance
Wear values that are assigned to the particular geometry parameters
via xy, whereby x corresponds to the number of the wear value and
y establishes the reference to the geometry parameter.
Setting-up values that are assigned to the particular geometry
parameter via xy, whereby x corresponds to the number of the
setting-up value and y establishes the reference to the geometry
parameter.
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Job Planning