Predrilling A Contour Pocket - Cycle64 - Siemens SINUMERIK 840D sl Programming Manual

Programming cycles externally
18.1 Technology cycles
Note
If the following transfer parameters are programmed indirectly (as parameters), the input
mask is not reset:
_VARI
18.1.28

Predrilling a contour pocket - CYCLE64

Programming
CYCLE64(STRING[100] _PRG, INT _VARI, REAL _RP, REAL _Z0, REAL _SC,
REAL _Z1, REAL _F, REAL _DXY, REAL _UXY, REAL _UZ, INT _CDIR,
STRING[20] _TR, INT _DR, INT _UMODE, INT _GMODE, INT _DMODE, INT
_AMODE)
Parameter
No. Param Param
mask internal
1 PRG _PRG
_VARI
2
3 RP _RP
4 Z0 _Z0
5 SC _SC
6 Z1 _Z1
7 F _F
DXY _DXY
8
9 UXY _UXY
10 UZ _UZ
11 _CDIR
12 TR _TR
13 DR _DR
688
, _ , , ,
RL _AS1 _AS2 _UMODE
Explanation
Name of drilling/centering program
Machining type
UNITS: Reserved
TENS: Reserved
HUNDREDS: Reserved
THOUSANDS: Lift mode
0 = Lift off to retraction plane
1 = Lift off to reference point + safety clearance
Retraction plane (abs)
Reference point (abs)
Safety clearance (to be added to reference point, enter without sign)
Drilling/centering depth (see _AMODE UNITS)
Drilling/centering feedrate
Infeed plane - unit (see AMODE TENS)
Finishing allowance, plane
Finishing allowance, depth
Milling direction
0 = Down-cut
1 = Up-cut
Reference tool name
Reference tool D number
, , ,
_GMODE _DMODE _AMODE
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Job Planning