Circle Of Holes - Holes2 - Siemens SINUMERIK 840D sl Programming Manual

No. Param Param
mask
internal
8 _VARI
9 _UMODE
10 αX _ANG1
11 αY _ANG2
12 _HIDE
_NSP
13
14 _DMODE
18.1.13

Circle of holes - HOLES2

Programming
HOLES2(REAL CPA, REAL CPO, REAL RAD, REAL STA1, REAL INDA, INT NUM,
INT _VARI, INT _UMODE, STRING[200] _HIDE, INT _NSP, INT _DMODE)
Parameters
No. Param Param
mask
intern
1 X0 CPA
2 Y0 CPO
3 R RAD
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Explanation
Machining type
UNITS: Position pattern
0 = Grid
1 = Frame
TENS: Reserved
HUNDREDS: Reserved
Reserved
Shear angle with 1st axis (lines arranged obliquely to the 1st axis)
< 0 = Clockwise measurement (0 to -90 degrees)
> 0 = Counter-clockwise measurement (0 to 90 degrees)
Shear angle with 2nd axis (lines arranged obliquely to the 2nd axis)
< 0 = Clockwise measurement (0 to -90 degrees)
> 0 = Counter-clockwise measurement (0 to 90 degrees)
Hidden positions
Max. 198 characters

Specification of consecutive position numbers, e.g. "1,3" (positions 1 and 3 are not

executed)
Reserved
Display mode
UNITS: Machining plane G17/18/19
0 = Compatibility, the levels effective before cycle call remain active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Explanation
Center point for circle of holes along the 1st axis (abs)
Center point for circle of holes along the 2nd axis (abs)
Radius of the circle of holes
Programming cycles externally
18.1 Technology cycles
659