Modal Subprogram Call (Mcall) - Siemens SINUMERIK 840D sl Programming Manual

1.24.3.4

Modal subprogram call (MCALL)

Function
For a modal subprogram call with
executed after each block with path motion. This allows subprogram calls to be automated,
which are to be executed at different workpiece positions (for example to create drilling
patterns).
MCALL
modal subprogram call for a new subprogram.
Note
Only one
transferred once for an
In the following situations the modal subprogram is also called without motion programming:
 Programming addresses
 If
Note
No modal subprogram calls are made in ASUBs that would interrupted by the processing of
a part program (see "Interrupt routine (ASUB) (Page 121)").
However, ASUBs that were started from the reset state behave like normal part programs
with regard to the modal subprogram calls.
Syntax
MCALL <program name>
Meaning
MCALL
<program name>
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
is used to deactivate the function without a subprogram call or by programming a new
call can be effective at one time in a program run. Parameters are only
MCALL
MCALL
/ were programmed alone in the block or with additional
G0 G1
: Command for the modal subprogram call
: Name of subprogram
, the subprogram is automatically called and
MCALL
call.
and if or is active.
S F G0 G1
Flexible NC programming
1.24 Subprogram technique
codes.
G
191