Drilling, Counterboring - Cycle82 - Siemens SINUMERIK 840D sl Programming Manual

No. Param Param
mask internal
_GMODE
7
8 _DMODE
9 _AMODE
18.1.3

Drilling, counterboring - CYCLE82

Programming
CYCLE82(REAL RTP, REAL RFP, REAL SDIS, REAL DP, REAL DPR, REAL DTB,
INT _GMODE, INT _DMODE, INT _AMODE)
Parameters
No. Param Param
mask intern
1 RP RTP
Z0 RFP
2
3 SC SDIS
4 Z1 DP
5 Z1 DPR
6 DT DTB
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Explanation
Geometrical mode (evaluation of programmed geometrical data)
UNITS: Reserved
TENS: Centering with respect to depth/diameter
0 = Compatibility, depth
1 = Diameter
Display mode
UNITS: Machining plane G17/G18/G19
0 = Compatibility, the plane effective before cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Alternative mode
UNITS: Drilling depth Z1 (abs/inc)
0 = Compatibility, from DP/DPR programming
1 = Incremental
2 = Absolute
TENS: Dwell time at final drilling depth DT in seconds/revolutions
0 = Compatibility, from DTB sign (> 0 seconds or < 0 revolutions)
1 = In seconds
2 = In revolutions
Explanation
Retraction plane (abs)
Reference point (abs)
Safety clearance (to be added to reference point, enter without sign)
Drilling depth (abs), see _AMODE
Drilling depth (inc), see _AMODE
Dwell time at final drilling depth, see _AMODE
Programming cycles externally
18.1 Technology cycles
643