Table of Contents
Advertisement
Configuring/Programming
8.5 Configuration control
Procedure
To set up the configuration control, follow these steps:
Step
8.5.2
Configuring
Requirements
● Configuration control only works with PROFINET.
● One CIM4310 PROFINET version V2.1 and higher
Required steps
When configuring the CIM4320 in STEP 7 (TIA Portal), enable the "Configuration control on"
parameter.
8.5.3
Control
8.5.3.1
Slot assignment
Slot assignment
The following table shows the possible slots for the various modules:
Table 8- 1
Modules
CIM PN
CIM
PM
POM
94
Procedure
1
Enable configuration control in STEP 7
2
Create control data record
3
Transfer control data record
Slot assignment
Possible slots
0
1.1
1.2
2 to 25
See section
Configuring (Page 94)
Control data record (Page 95)
Transferring the control data record in the startup
program of the CPU (Page 98)
Comment
The PN connection of the CIM is not an element of
the configuration control.
The header of the CIM (subslot) is not an element of
the configuration control, but instead controls it.
As a sub-slot part of the configuration control (han-
dled here as a slot 1).
Without empty slot directly after the CIM.
SIPLUS HCS4300 PROFINET/PROFIBUS DP
Operating Instructions, 10/2019, A5E35452705A/005
Advertisement
Table of Contents
