After Installation; Table 3-2 Slot Numbers; Figure 3-3 Attaching The Slot Numbers To The Modules - Siemens SIMATIC ET 200PA SMART Operating Instructions Manual

Installation
3.2 Installation
3.2.4

After installation

Assigning slot numbers
After installation, you can assign a slot number to each module. The following table illustrates
the assignment of the slots.
Table 3-2
Slot number
The use of the power supply is optional.
1
Unoccupied slots
In a configuration of an ET 200PA SMART with active bus modules, if slots are unoccupied (e.g.
reserved for later use), you must leave these slots free when configuring!
Attaching slot numbers
The following figure shows how you must attach the slot numbers. The slot number plates are
provided with the IM 650.
Figure 3-3
38
Slot numbers
Module
1
2
3
4
5
...
15
Attaching the slot numbers to the modules.
Power supply (PS)
1
IM 650
–
Module 1
Module 2
...
Module 12
Operating Instructions, 06/2019, A5E34192013-AB
Remark
–
–
Not applicable
Directly to the right of IM 650
–
–
–
ET 200PA SMART