Slots On A Circle - Slot1 - Siemens SINUMERIK 808D User Manual

12.6.7

Slots on a circle - SLOT1

Programming
SLOT1 (RTP, RFP, SDIS, DP, DPR, NUM, LENG, WID, CPA, CPO, RAD, STA1, INDA, FFD, FFP1, MID, CDIR, FAL, VARI,
MIDF, FFP2, SSF, FALD, STA2, DP1)
Pa rameter
Pa rameter D a ta type
RTP REAL
RFP REAL
SDIS REAL
DP REAL
DPR REAL
NUM INT
LENG REAL
WID REAL
CPA REAL
CPO REAL
RAD REAL
STA1 REAL
INDA REAL
FFD REAL
FFP1 REAL
MID REAL
CDIR INT
FAL REAL
VARI INT
MIDF REAL
FFP2 REAL
SSF REAL
FALD REAL
STA2 REAL
DP1 REAL
N o te
The cycle requires a milling cutter with an "end tooth cutting across center" (DIN844).
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
D e scription
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Slot depth (absolute)
Slot depth relative to the reference plane (enter without sign)
Number of slots
Slot length (enter without sign)
Slot width (enter without sign)
Center point of circle (absolute), first axis of the plane
Center point of circle (absolute), second axis of the plane
Radius of the circle (enter without sign)
Starting angle
Incrementing angle
Feedrate for depth infeed
Feedrate for surface machining
Maximum infeed depth for one infeed (enter without sign)
Milling direction for machining the slot
Values: 2 (for G2), 3 (for G3)
Finishing allowance at the slot edge (enter without sign)
Machining type
Values: 0 = complete machining, 1 = roughing, 2 = finishing
Maximum infeed depth for finishing
Feedrate for finishing
Speed for finishing
Finishing allowance at the slot base (enter without sign)
Maximum insertion angle for oscillation movement
Insertion depth per revolution for helix (incremental)
211