Digital Equipment DEC 3000 Series Service Information page 247

Upgrading Firmware, Using a CD–ROM,
Sample
Upgrade
Session, Using
a CD–ROM
In the following sample session, all user input is in bold typee.
Comments begin with an exclamation point (!).
Return
>>> BOOT DKA400
INIT-S-CPU...
AUDIT_CHECKSUM_GOOD
AUDIT_LOAD_DONE
*** FIRMWARE UPDATE UTILITY V7.3 ***
*** SYSTEM TYPE: MODEL 500 ***
UPDATE
VERIFY
LIST
SHOW
SET
?
Return
UPD->UPDATE
READ IO ROM DEVICE ID
UPD-I VERIFY LOADED ROM IMAGE
...............................
UPD-I VERIFY LOADED ROM IMAGE DONE
MANUFACTURER INTEL (0x89)
DEVICE CODE = 28F020 (0xBD) 256K x 8
UPDATE SYSTEM ROM DEVICE
UPD-I VERIFY LOADED ROM IMAGE
................................
UPD-I VERIFY LOADED ROM IMAGE DONE
FIRMWARE REVISION: BLx.x LENGTH: 0xfirm_upgrade3FF28 -> 261928
BYTES
CHECKSUM: 0xdf
MANUFACTURER = INTEL (0x89)
DEVICE CODE =28F020 (0xbd) 256k x 8
UPD-I *** ROM CONTENTS WILL BE DESTROYED ***
UPD I ARE YOU READY TO PROGRAM DEVICE ? (Y/N) Y !Program
prompts for decision
UPD-I PRECHARGING DEVICE
..........................................................
!Boot RRD42 load update program
! See Table A-1
! See Table A-1
! See Table A-1
! See Table A-1
! See Table A-1
! See Table A-1
! Update Utility prompt,user input required
Continued
Continued on next page
A–3