Troubleshooting Tables,
Continued
Table 6–20 (Continued) System Problems
Symptom
Possible Cause
Default recovery
action is set to halt.
Incorrect boot
device was
specified.
Boot device is not
configured properly.
Faulty boot device
Corrective Action
In console mode
(>>>), enter the
SHOW AUTO_
ACTION command
to find the proper
setting. Use the
SET AUTO_
ACTION command
to change the setting.
See Chapter 3
for command
descriptions.
In console mode
(>>>), enter the
SHOW BOOTCMD_
DEV command to
find the proper
setting. Use the
SET BOOTCMD_
DEV command to
change the setting.
See Chapter 3
for command
descriptions.
Use the SHOW
DEVICE command
to check that all
devices are configured
properly. If not, check
SCSI ID settings and
SCSI cables.
Run SCSI diagnostic
utilities (Chapter 4).
Continued on next page
6–21