Digital Equipment DEC 3000 Series Service Information page 278

NI Diagnostic Error Codes,
C–26
Error
Code Description
34 LANCE initialization: transmitter disabled.
36 LANCE initialization: receiver enabled.
38 LANCE initialization: transmitter enabled.
40 LANCE internal loopback/DMA: initialization failed.
42 LANCE internal loopback/DMA: transmit failed.
44 LANCE internal loopback/DMA: receive failed.
46 LANCE internal loopback/DMA: packet comparison
failed.
48 LANCE internal loopback/DMA: init DMA error.
4A LANCE internal loopback/DMA: transmit DMA error.
4C LANCE internal loopback/DMA: receive DMA error.
4E LANCE internal loopback/DMA: unknown tx or rx
error.
50 LANCE interrupts: initialization failed.
52 LANCE interrupts: TC interrupt register bit not set.
54 LANCE interrupts: SIR NI interrupt register bit not
set.
56 LANCE interrupts: NI ISR not entered.
60 LANCE CRC: initialization failed.
62 LANCE CRC: transmit failed.
64 LANCE CRC: receive failed.
66 LANCE CRC: packet comparison failed.
68 LANCE CRC: LANCE generated bad CRC.
6A LANCE CRC: LANCE rejected good CRC.
6C LANCE CRC: LANCE accepted bad CRC.
6E LANCE CRC: Other error.
70 LANCE rx MISS/BUFF: initialization failed.
72 LANCE rx MISS/BUFF: transmit failed.
74 LANCE rx MISS/BUFF: unknown receive error.
76 LANCE rx MISS/BUFF: MISS error not flagged.
78 LANCE rx MISS/BUFF: BUFF error not flagged.
80 LANCE collision: initialization failed.
82 LANCE collision: unknown transmit error.
Continued
Continued on next page