Digital Equipment DEC 3000 Series Service Information page 310

Installation Procedure
(IEC RS–310 Cabinet),
Assemble
the Top Air
Deflector
and Baffle
Subassembly
Install the Top
Air Deflector
Assembly
E–4
Continued
Required materials:

Six 6/32 screws

Top air baffle (PN 74–46195–01)

Top air deflector (PN 74–46196–01)
To assemble the top air deflector and baffle subassembly
(Figure E–2):
Steps Action
1 Align the holes in the deflector
baffle .
2 Insert and tighten the six screws to secure the baffle to
the deflector.
Required materials:

Four 10/32 screws with integral washers

Six clip nuts (PN 90-07786-00)

Top air deflector assembly (assembled in previous section)
To install the top air deflector assembly (Figure E–2):
Steps Action
1 Attach clip nuts to each tab
2 Count up 26 holes from the bottom of the installation
area on the front and rear cabinet rails, as shown in
Figure E–1.
3 Use the four 10/32 screws to secure the top air deflector
assembly to the cabinet rails.
to the holes in the
on the deflector as shown.
Continued on next page