Installation Procedure
(IEC RS–310 Cabinet),
Assemble the
Right Side
Chassis Slide
Subassembly
(continued)
E–10
Continued
To assemble the right side chassis slide subassembly (Figure E–4):
Steps
Action
1
Orient the slide mounting bracket
facing out.
2
Use four 8/32 screws to secure the slide mounting
brackets to the chassis slide
screws at the rear slide mounting bracket.
3
Use four 8/32 screws to secure the slide mounting angle
brace
to the chassis slide.
so the IEC end is
. Do not tighten the two
Continued on next page