Digital Equipment DEC 3000 Series Service Information page 130

Running Diagnostic Tests,
Running
a Single
Diagnostic Test
Example
Running
Diagnostic
Subtests
Example
Running
Multiple
Diagnostic
Tests
4–6
To run a single test, enter the following command:
>>> T[EST] {device name}
This example executes the NVR diagnostic:
Return
>>> T NVR
When you select a test without specifying subtests, the diagnostic
runs all associated subtests.
To run a diagnostic subtest, enter the following command:
>>> T[EST] {device name} {subtest}
This example selects the TOY subtest of the NVR diagnostic.
NVR testing is performed only on those areas defined by the TOY
subtest.
Return
>>> T NVR TOY
You can specify different combinations of diagnostics, depending
on your needs. The system performs tests one at a time, in the
order specified on the command line. Some diagnostics require

Service mode

Loopback connectors
You can specify individual tests or ranges of tests:
>>> T[EST] {device name}, {device name}...
>>> T[EST {device name}:{device name}
>>> T[EST] {device name}:{device name},{device name}...
Continued
Return
Return
Return
Return
Return
Continued on next page