Digital Equipment DEC 3000 Series Service Information page 292

SCSI Diagnostic Status/Error Messages,
C–40
? T-ERR-SCSI (bus) - Min Dev test - start unit
? T-ERR-SCSI (bus) - Min Dev test - test unit ready
? T-ERR-SCSI (bus) - Min Dev test - rewind
? T-ERR-SCSI (bus) - Min Dev test - mode select
? T-ERR-SCSI (bus) - Min Dev test - read
? T-ERR-SCSI (bus) - Min Dev test - send diagnostic
T-ERR-SCSI (bus) - id = (device id) lun = (logical unit number)
info = (informational value)
T-ERR-SCSI (bus) - actcmd = (actual command)
curcmd = (current command)
status = (status) int = (interrupt)
T-ERR-SCSI (bus) - IR = (ir) CIR = (cir) IME = (ime)
T-ERR-SCSI (bus) - snskey = (sense key) extfru = (extended fru info)
? T-ERR-SCSI (bus) - Min Dev test - wrong num bytes
? T-ERR-SCSI (bus) - Min Dev test - data miscompare
T-ERR-SCSI (bus) - id = (device id) lun (logical unit number)
where:
= Sparse address of failing location
address
- Expected data
exp data
- Actual data
actual data
= A or B
bus
= SCSI id
device id
logical unit number
= informational value from following table
info
= original command that was sent to SCSI bus
actcmd
= actual command that failed
curcmd
= SCSI controller status register contents at time of error
status
= SCSI controller interrupt register contents at time of
interrupt
error
= TURBOchannel interrupt register contents at time of error
ir
= DUAL SCSI ASIC control interrupt register contents at time
cir
of error
= DUAL SCSI ASIC interrupt mask enable register contents
ime
at error.
= virtual address of data
data addr
= map register address
map reg adr
= logical unit number of device
Continued
Continued on next page