Installation Procedure
(IEC RS–310 Cabinet),
Install the
Bottom Air
Deflector
Assembly
E–8
Continued
Required materials:
Four 10/32 screws with integral washers
14 clip nuts (PN 90-07786-00)
Bottom air deflector assembly (assembled in the previous
section)
To install the bottom air deflector assembly (Figure E–3):
Steps
Action
1
Attach clip nuts to each tab
2
Count up four holes from the bottom of the installation
area at the front of the cabinet and two holes at the rear
of the cabinet.
3
Use the four 10/32 screws to secure the bottom air
deflector assembly to the cabinet rails.
4
Install clip nuts in holes 6, 10, 14, and 20 on the front
cabinet rails. Install clip nuts in holes 6, 10, 20, and 23
on the rear cabinet rails. See Figure E–1.
on the deflector as shown.
Continued on next page