Digital Equipment DEC 3000 Series Service Information page 328

Installation Procedure
(IEC RS–310 Cabinet),
Install the
Faceplate
Mounting
Brackets
E–22
Continued
Required materials:

Two 6/32 screws

Six 10/32 screws

Right mounting bracket (PN 74–45544–01)

Left mounting bracket (PN 74–45543–01)
To install the faceplate mounting brackets Figure E–10):
Steps Action
1 Use the two 6/32 screws to secure the right faceplate
mounting brackets
The left faceplate bracket is secured using screws that
are already in place on the power supply.
2 Count up 2 holes, 14 holes, and 20 holes from the bottom
of the installation area on the front cabinet rails.
3 Install clip nuts at the locations determined in step 2 (if
not already installed).
4 Push the PE50A-B9/D9 unit into the cabinet.
5 Use the six 10/32 screws to secure the faceplate
mounting brackets
to the system .
to the cabinet.
Continued on next page