Installation Procedure
(IEC RS–310 Cabinet),
Install the Left
Side Chassis
Slide Assembly
E–16
Continued
Required materials:
Left side chassis slide assembly (assembled in the previous
section)
Two 10/32 screws
To install the left side chassis slide assembly (Figure E–7):
Steps
Action
1
Count up 6 holes from the bottom of the installation area
on the front and rear cabinet rails.
2
Count up 10 holes from the bottom of the installation
area on the front and rear cabinet rails.
3
Align the chassis slide assembly
tenth hole, then secure the assembly to the cabinet rails
.
4
Tighten the two screws at the rear slide mounting
bracket.
to the sixth and
Continued on next page