Digital Equipment DEC 3000 Series Service Information page 332

Installation Procedure
(IEC RS–310 Cabinet),
Install the
Rear Support
Bracket
E–26
Continued
Required materials:

Two 6/32 screws

Rear support bracket (PN 74–45545–02)

Four 10/32 screws
To install the rear support bracket (Figure E–12):
Steps Action
1 On the rear cabinet rails, count up 20 holes and 26 holes
from the bottom of the installation area. Install clip nuts
on these holes, if not already installed.
2 Use the two 6/32 screws to secure the rear support
bracket
3 Use the four 10/32 screws to secure the rear support
bracket to the rear of the cabinet.
to the rear of the PE50A–B9/D9 unit .
Continued on next page