Digital Equipment DEC 3000 Series Service Information page 352

Installation Procedure
(H9A00-AJ Cabinet),
Assemble
the Left Side
Chassis Slide
Subassembly
F–14
Continued
Required materials:

Eight 8/32 screws

Eight nuts

Two slide mounting brackets (PN 74–46197–01)

Chassis slide (PN 12–18166–02)

Slide mounting angle brace (PN 74–45548–01)
The slide mounting brackets have two mounting ends.
One end is for IEC mounting, and the other is for metric
mounting. See Figure F–6.
To assemble the left side chassis slide subassembly (Figure F–6):
Steps Action
1 Orient the slide mounting bracket
facing out.
2 Use four 8/32 screws to secure the slide mounting
brackets to the chassis slide
screws at the rear slide mounting bracket.
3 Use four 8/32 screws to secure the slide mounting angle
brace to the chassis slide.
NOTE
so the IEC end is
. Do not tighten the two
Continued on next page