Lifting - Danfoss VLT AQUA Instruction Manual
High power
Hide thumbs
Also See for VLT AQUA:
- Programming manual (298 pages) ,
- Design manual (228 pages) ,
- Instruction (206 pages)
Table of Contents
Advertisement
3 How to Install
3.2.4 Lifting
Always lift the adjustable frequency drive using the dedicated lifting holes. For all D and E2 (IP00) frames, use a bar to avoid bending the lifting holes of
the adjustable frequency drive.
3
Figure 3.3: Recommended lifting method, frame sizes D and E .
NOTE!
The lifting bar must be able to handle the weight of the adjustable frequency drive. See
different frame sizes. Maximum diameter for bar is 1 in [25 cm]. The angle from the top of the drive to the lifting cable should be 60
degrees or greater.
Figure 3.4: Recommended lifting method, frame size F1.
3-4
Figure 3.5: Recommended lifting method, frame size F2.
®
MG.20.P3.22 - VLT
is a registered Danfoss trademark
VLT AQUA High Power Instruction Manual
Mechanical Dimensions
for the weight of the
Advertisement
Table of Contents
Need help?
Do you have a question about the VLT AQUA and is the answer not in the manual?
Questions and answers