Danfoss VLT AQUA Instruction Manual page 99

VLT AQUA High Power Instruction Manual
[Off]
stops the connected motor. The key can be
If no external stop function is selected and the [Off] key is inactive, the motor can be stopped by disconnecting the line power supply.
[Auto on]
enables the adjustable frequency drive to be controlled via the control terminals and/or serial communication. When a start signal is applied to the control
terminals and/or the bus, the adjustable frequency drive will start. The key can be
NOTE!
An active HAND-OFF-AUTO signal via the digital inputs has higher priority than the control keys [Hand on] [Auto on].
[Reset]
is used for resetting the adjustable frequency drive after an alarm (trip). The key can be
4.1.4 Changing Data
1. Press the [Quick Menu] or [Main Menu] key.
▲ ▼
2.
Use [ ] and [ ] keys to find parameter group to edit.
3. Press the [OK] key.
▲ ▼
4.
Use [ ] and [ ] keys to find parameter to edit.
5. Press the [OK] key.
▲ ▼
6.
Use the [ ] and [ ] keys to select the correct parameter setting. Or, to move to digits within a number, use the keys. The cursor indicates the
digit selected to be changed. The [
7. Press the [Cancel] key to disregard the change, or press the [OK] key to accept the change and enter the new setting.
Enabled Disabled
[1] or [0] via par. 0-41
▲ ▼
] key increases the value, the [ ] key decreases the value.
®
MG.20.P3.22 - VLT is a registered Danfoss trademark
4 How to operate the adjustable frequency
[Off] Key on LCP
.
Enabled Disabled
[1] or [0] via par. 0-42
Enabled Disabled
[1] or [0] via par. 0-43
drive
[Auto on] Key on LCP
.
4
[Reset] Key on LCP
.
4-9