Upgrading Technology Packages - Siemens SIMOTION D410 Series Commissioning Manual

3. Move the new module to the top field of the module rack using drag-and-drop.
Figure 5-8
4. Confirm the dialog box that appears with "Yes" if you want to replace the
5. Accept the changes made to the hardware configuration with "Station" > "Save and
6. Close HW Config.
If the module hardware changes (e.g. the D410 DP is replaced with the D410 PN), proceed
as described in the section titled Removing and replacing the SIMOTION D410 (Page 166).
5.3.8

Upgrading technology packages

Overview
The SIMOTION technology packages (e.g. TP CAM, TP PATH, DCBlib) are available in
various versions.
SIMOTION D410
Commissioning Manual, 02/2012
5.3 Adapting a project (Upgrading the project / Replacing the SIMOTION controller)
HW Config module replacement
SIMOTION device. The module is replaced.
Compile".
Note
From SIMOTION SCOUT V4.2, when modules are replaced the following actions are
performed automatically by the engineering system, as necessary:
• Update of the technology packages (TPs)
• Automatic upgrade of the SINAMICS Integrated
The updated data is transferred to the project and the entire project saved.
Maintenance and service
179