Siemens SIMOTION D410 Series Commissioning Manual page 102

Commissioning (software)
4.5 Testing the configured drive using the drive control panel
Prerequisites
● The project has been downloaded to the target system.
● SIMOTION SCOUT is in online mode.
● The drive is not in use by a current project in RUN mode.
Testing the drive using the drive control panel
1. Change to the configured drive in the Project Navigator and open the drive control panel
Figure 4-16
2. To display the control range and axis diagnostics, click the "Show/hide control range" and
3. Click "Assume control priority". The "Assume Control Priority" dialog box opens.
102
WARNING
Make sure that the drive test does not pose any risk to persons.
by selecting "Commissioning" > "Control panel". The drive control panel opens in the
detail view.
Drive control panel
"Show/hide diagnostics area" buttons.
Figure 4-17 Assuming control priority
SIMOTION D410
Commissioning Manual, 02/2012