When Power Distribution Units (2U) Are Installed - Fujitsu ETERNUS DX S5 Series Configuration Manual

4. Connecting Cables
Power Cord Connection

When Power Distribution Units (2U) Are Installed

The following procedure explains how to connect the power cords when a 2U power distribution unit (16 outlet
type) is installed.
1
Remove the cable holders from the power distribution unit.
Loosen the eight M3 screws on both sides of the cable holder to remove it.
2
Connect the power distribution unit outlets and power supply unit inlets with the power cords (AC output
cables).
The procedure to connect the power supply unit is same as
Are Installed" (page
IMPORTANT
• Connect the PSU#0 power cord to power distribution unit#0 (the lower power distribution unit).
Connect the PSU#1 power cord to power distribution unit#1 (the higher power distribution unit).
• For the high-density drive enclosure, connect the PSU#0 and PSU#2 power cords to power
distribution unit#0 (the lower power distribution unit). Connect the PSU#1 and PSU#3 power
cords to power distribution unit#1 (the higher power distribution unit).
58).
61
Cable holder
M3 screw
M3 screw
Step 1 in "When No Power Distribution Units
Configuration Guide (Basic)